Cebora 285 Aluminum Inverter Pulse Mig Welder
Approved by Mercedes-Benz, Smart, Sprinter, Maybach, BMW, Ferrari, Maserati, Toyota, Lexus, Mazda, KIA, Land Rover, Renault and Ford.

The CEBORA Pulse Mig was designed and developed to meet the critical welding requirements of today’s high-tech collision shops. Car manufacturers that have an aluminum welding repair procedure specify that the repair must be performed with a PULSE MIG. The Pulse Mig #285 circuitry allows this inverter to weld very thin aluminum with full penetration without burning through. To simplify and reduce set-up time, the PULSE MIG 285 is pre-programmed for welding aluminum, high strength steels and MIG brazing of galvanized steel. Just look up the alloy to weld on the “menu”, enter the code and the machine presets all the parameters such as wire speed and voltage. No more guesswork. The Pulse Mig 285 uses a push pull gun for trouble-free aluminum wire feed. (See page on PUSH PULL GUN for details)

• INVERTER Technology

• Aluminum welding

• Safe to use near computer, PTC, etc.

• Mig Brazing on galvanized steel.

• Pre-programmed settings for fast & easy set-up.

• Pulse feature, vital for aluminum welding.

• Push-Pull gun compatible for trouble free use of

aluminum wire.

• Download program updates, to keep you current

to the newest settings.

Technical Specifications

• 220 Volt single phase @ 40 amps 50/60 Hz

• Output power 15-200 amps

• Duty cycle 35% @ 200 amps and

60% @ 160 amps

• Power cord 8’ (2.5m)

• Ground cable 9’ (3m)

• Measurements: 11” x 18” x 19”

• Weight: 44 lbs.

• Mig Gun sold separately. See CEBORA Push Pull

Gun Item #2003